Cheap Vinyl Cutters

Tools:

• Phillips Screw Driver
• Needle Nose Pliers

Steps:

1. Put together the stand.
2. Unscrew the grounding screw on the back right hand side of the cutter.
3. Screw in the grounding strap end, and crimp the wire inside of it. Use a pair of needle nose pliers.
4. Wrap the grounding wire around the support beam running across the stand.
5. On the support beam on the right hand side (looking from the front) there is a hole for a screw.
6. Screw the other end of the grounding strap into the beam.
7. Place the cutter on the stand. Ideally have someone help you. The rubber feet go in the holes.
8. Install the knife or plotter pen.
9. Choose your communication cable, USB, Serial, Parralel etc
10. Plug that bad boy into the wall!